opening on an end cap

  • fuzz81
  • fuzz81's Avatar Topic Author
  • Offline
  • New Member
  • New Member
More
16 years 2 months ago - 16 years 2 months ago #7274 by fuzz81
opening on an end cap was created by fuzz81
hi, can we make an opening/hole to attached the flangolet on an end cap?End cap size is 24" and flangeolet size is 2". Is there any standards regarding this issue?thanx....

Please Log in or Create an account to join the conversation.

More
16 years 2 months ago - 16 years 2 months ago #4477 by Jop
Replied by Jop on topic Yes you can do it!
Yes you can do it!
It is done all the time. Example: the drain connection on the bottom of a "Boot" on a Steam Line.

Do it once and Do it Right

Please Log in or Create an account to join the conversation.

  • fuzz81
  • fuzz81's Avatar Topic Author
  • Offline
  • New Member
  • New Member
More
16 years 2 months ago - 16 years 2 months ago #4478 by fuzz81
Replied by fuzz81 on topic even though for the high
even though for the high pressure line? can we use the same material as normally used carbon steel material for the end cap which is ASTM A234-WPB?

Please Log in or Create an account to join the conversation.

More
16 years 2 months ago - 16 years 2 months ago #4479 by Jop
Replied by Jop on topic You may need to give
You may need to give more information.

If you are saying what I think you are saying then remember the following:

The material of both component's should be the same.

Do it once and Do it Right

Please Log in or Create an account to join the conversation.

  • fuzz81
  • fuzz81's Avatar Topic Author
  • Offline
  • New Member
  • New Member
More
16 years 2 months ago - 16 years 2 months ago #4480 by fuzz81
Replied by fuzz81 on topic it is the same material
it is the same material but in different strength and method i guess...is it using as the same tapping procedure as a flangolet tapping on the blind flange?is there any statement regarding these issue on ASME B31.3?the line is 38barg and temperature is 110/-29 (design condition).it is applied as an inverted boot for process gas line.thanx... ..

Please Log in or Create an account to join the conversation.

Moderators: Jop
Time to create page: 0.268 seconds