- Posts: 3
- Thank you received: 0
Dear friends
- vijayram
-
Topic Author - Offline
- New Member
-
Less More
10 years 6 months ago - 10 years 6 months ago #8357 by vijayram
Dear friends was created by vijayram
Kindly give the suggestion for steam line stress analysis
when i do the stress analysis all code compliance passed in the allowable limits but the displacement value are showing higher at few node places.normally how to reduce the displacement value. what is the limits should be.
thanks
vj
when i do the stress analysis all code compliance passed in the allowable limits but the displacement value are showing higher at few node places.normally how to reduce the displacement value. what is the limits should be.
thanks
vj
Please Log in or Create an account to join the conversation.
- Jop
-
- Offline
- Moderator
-
Less More
- Posts: 1053
- Thank you received: 14
10 years 6 months ago - 10 years 6 months ago #6934 by Jop
Do it once and Do it Right
Replied by Jop on topic Re: Dear friends
Which Temperature did you use for your calculations:
- the Design Temperature?
or
- the Maximum Operating Temperature?
If you used the Design Temperature then you were wrong.
You should follow the Code and use the Maximum Operating Temperature. Doing so you will have less displacement and lower stress values.
- the Design Temperature?
or
- the Maximum Operating Temperature?
If you used the Design Temperature then you were wrong.
You should follow the Code and use the Maximum Operating Temperature. Doing so you will have less displacement and lower stress values.
Do it once and Do it Right
Please Log in or Create an account to join the conversation.
Moderators: Jop
Time to create page: 0.231 seconds
